Connect and share knowledge within a single location that is structured and easy to search. Unfortunately, I cannot seem to do so. For one, it doesn't seem to be detecting any Hard Drives attached to the Server. Also, while inserting the SmartStart CD 7. Could anyone please advise as to what other needs to be done to format my server? I went through some questions here on ServerFault and the HP guides here but they weren't of much help to a n00b like me. In order to resolve your situation, you should understand that the server has an onboard Smart Array 6i RAID controller embedded on the motherboard.
The SCSI controller traditionally only worked if there wasn't anything connected to the pin SCSI connector on the edge of the motherboard see 1 below. The key to this are the drive backplane and the motherboard connections. There are several cabling options in this system; simplex, duplex and a few bypass arrangements that enable the use of higher-end RAID controllers.
You want your backplane-to-motherboard connection to look like this assuming you wish to see all six drive bays on the motherboard controller. This assumes you don't have any PCI-X cards in the riser cage. If you do have a card installed and there's a pin SCSI cable connecting it to the backplane, remove the cable s and change to the above configuration.
The jumper cable 2 is key. You probably just have an Adaptec controller in the PCI slot with the drive backplane cabled to it. Change the configuration to what's described in the diagram above, and you'll be able to use the onboard HP controller. After doing that, you will be able to format it. Right now, the RAID controller sees that it has raw disks, but no volumes have been created, so there is nothing to present to the OS or installer, rather ; you just need to initialize a volume.
Try to make sure the backpane is properly connected I have had them dc frequently after transport. Sign up to join this community. The best answers are voted up and rise to the top. Stack Overflow for Teams — Collaborate and share knowledge with a private group. Pure Capsaicin. Install the smartstart CD that came with it, all the drivers are on there. I would advise against using server I have already done but there is only one type of display no choice.
You may need to add a discrete video card to it. Better yet, virtualize it. Normal breakpoints, "bp", can only be set if the debugger is attached at boot time. Hardware breakpoints, "ba", can be set at any time. Arguments: Arg1: a3a03afeea, Reserved Arg2: , Reserved Arg3: bbecbeb, Failure type dependent information Arg4: , Type of corrupted region, can be 0 : A generic data region 1 : Modification of a function or.
The issue you posted is related to Server and would be better suited in the TechNet community. Please visit the link below to find a community that will offer the best support. Was this reply helpful? Yes No. Sorry this didn't help.
0コメント